Tungsten Trioxide Thin Film Preparation
Tungsten oxide (WO3) thin film is a kind of important functional material due to the advantages of WO3 thin films have higher transmittance change, good reversibility, relatively low price, long service life and low toxicity. It is the earliest and the most widely used electrochromic materials. Tungsten oxide (WO3) thin film can employ in buildings and smart window.
The preparation methods of tungsten trioxide thin film include sol gel method, sputtering method and chemical vapor phase method. It makes special introduction of sol gel method and sputtering method.
1. Sputtering method
Sputtering method is an advanced method to prepare thin film which is characterized by high speed and low temperature, and the high density of the thin film.
It mainly refers to the ion source to generate ion. The ion increases and accumulates into high speed integrated ion in vacuum to bombard target surface. Then the ion and atoms of target surface undergoes kinetic exchange to make the atom of target surface leaving substrate surface, and finally forms into the film. Sputtering method is divided into direct current sputtering, radio frequency sputtering, magnetron sputtering, reactive sputtering, medium frequency sputtering, pulsed sputtering, bias sputtering and ion beam sputtering etc..
Direct current magnetron sputtering is prepared on silicon wafer with the thickness of tungsten oxide thin films 300nm. Specific methods: use 99.99% purity and the diameter is 10mm annular metal tungsten as target. The volume of argon and oxygen is based on ratio of 1:1 mixed gas as gas discharge. The pressure of discharge gas is 0.4~12Pa; the current is 50mA; the voltage changes with the pressure of the discharge gas; and the varying range is controlled at 540~420V. First close the sputtering chamber for five minutes before sputtering.
2. Sol gel method
The principle of sol gel method is that the precursor（inorganic salt or metal alcohol salt）is dissolved in the solvent to prepare solution by mixing the solution. The hydrolysis product is formed by the condensation reaction to form nano particles and a sol. On the basis of sol, you can take a dip coating, spin coating, spray pyrolysis, screen printing and so on to produce tungsten trioxide thin films.
Mix tungstate powder and 30% H2O2 of WO3 solution and stir continuously 2-4h to get peroxotungstic acid (PTA). PTA solution heats and losses water into the precursor powder, and then calcinates four hour in the air at 600℃ to obtain WO3 powder. The WO3 powder is dissolved in the organic solvent made of printing paste. Finally use screen printing method in alumina ceramic substrate to prepare tungsten oxide thin films.
Tungsten Oxide Supplier : Chinatungsten Online - http://tungsten-oxide.com
Tel.: 86 592 5129696; Fax: 86 592 5129797 Email: [email protected]
Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn
More details of the above news and/or products, please visit Chinatungsten Online, or contact us directly.
Disclaimer: The article is only reflecting the opinions of the author. We have no responsibility to prove the originality and authenticity of the content, words and/or pictures. You readers should just take it as reference and check the details by yourselves. And the content is not a suggestion for investment decision. The investor takes his or her own risks if he or she operates accordingly. If you have any dissent about the contents above, please contact the relevant author, or the webmaster. We will try our best to assist the dealing of the related issues. Thanks for your visit and cooperation.
|
